A flexible base for a custom 12 V bank
Grow the bank around changing needs
Matched 12 Ah batteries can form a larger system when a project outgrows a single pack. Follow the installation guidance for compatible wiring and charging.
Keep stored energy refreshed by solar
A compatible solar controller can recharge the battery for a small off-grid setup, emergency kit or equipment used away from utility power.
Protection stays inside every module
The built-in battery management system watches the cells for common electrical and temperature faults while the pack is in use.
Frequently asked questions
Can this battery be used for engine starting?+
No. The 12V 12Ah LiFePO4 battery is intended for compatible deep-cycle and backup-power applications, not engine starting.
What charger should I use?+
Use a LiFePO4-compatible charger with a 14.4–14.6 V charging profile. Keep the charging current at or below the published maximum of 6 A for this model.
Can batteries be connected in series or parallel?+
Yes, when configured according to the product instructions. The manual supports up to four batteries in series and four in parallel for this model; use matching batteries, keep the voltage difference at or below 0.3 V before connection, and do not exceed the specified current or protection limits.
What are the operating temperature limits?+
The published range is 0–50 °C while charging, −20–60 °C while discharging, and 0–45 °C for storage. Do not charge below 0 °C unless an approved low-temperature charging mode is explicitly provided.
What are the terminal type, dimensions and cycle rating?+
This model uses a T2 terminal and measures approximately 151 × 98 × 93 (L × W × H). Its published cycle-life figure is 5000+ cycles under the stated test conditions; actual service life depends on use and operating conditions.