Pairs well with

Backup power without giving up a shelf

Put backup power where the equipment lives - 600VA/360W LiFePO4 USV zur Wandmontage

Put backup power where the equipment lives

The compact enclosure can sit on a surface or mount on the wall, keeping a small home or office setup easier to arrange.

Let a NAS shut down cleanly - 600VA/360W LiFePO4 USV zur Wandmontage

Let a NAS shut down cleanly

The data connection gives compatible NAS software a power-failure signal so storage can close safely instead of stopping without warning.

Add a protected power point beside the desk - 600VA/360W LiFePO4 USV zur Wandmontage

Add a protected power point beside the desk

Wall placement keeps battery backup and surge protection close to the computer and router without taking over the work surface.

Technical specifications

Product

Model number
UPS-600VA-03BKW01
UPS topology
Standby

Power

Apparent power
600 VA
Active power
360 W

Physical

Form factor
Wall-mount
Dimensions (L × W × H)
297 × 149 × 87 mm
Net weight
3.1 kg

Input

Input voltage range
90–140 V
Input frequency
50/60 ±3 Hz
Input protection
125/250V~, 10A breaker

Output

Output voltage
120 ±10% V
Output frequency
60 ±3 Hz
Output waveform
Simulated Sine Wave
Transfer time
≤10 ms
Outlet / plug type
NEMA 5-15
Total outlets
5
USB / Type-C output
USB-A + USB-C, 5V/2A, 10W total

Runtime

Reference load
300 W
Backup time
~10 min
Recommended load range
216–252 W

Built-in battery

Battery chemistry
LiFePO4
Battery nominal voltage
25.6 V
Battery capacity
3 Ah
Battery energy
76.8 Wh
Recharge time
~3 h
Cycle life
3000+ cycles

Environment

Noise
≤40 @1m dB
Operating temperature
0–40 °C
Storage temperature
-15–40 °C
Operating humidity
20–90, non-condensing %RH

Frequently asked questions

How long will it run after the power goes out?

Under the published reference condition, this model provides about 10 minutes at a 300 W reference load. Actual runtime varies with connected load, temperature and battery condition.

What output waveform and transfer time does it use?

The UPS uses Simulated Sine Wave output with a specified transfer time of ≤10 ms. Compatibility still depends on the connected equipment and its power requirements.

How long does the built-in battery take to recharge?

The published recharge time is about 3 hours. Recharge time can vary with battery state, load and operating conditions; recharge the unit promptly after a low-battery event.

What outlets or communication interfaces are included?

5 NEMA 5-15 outlets plus USB-A and USB-C (5 V/2 A, 10 W total).

What load and maintenance limits should I follow?

Do not exceed this model’s rated 360 W output. Keep the UPS in a dry, ventilated indoor location, and stop use if it shows abnormal heat, odor, deformation or fault indications. Battery maintenance or replacement should be handled by qualified personnel.